HY-6000 Mirror ink 
 First, the product description and print the selection of the supporting facilities: 
 1, HY-6000 mirror ink for printing glass, tempered glass and other transparent material. 
 2, due to the low viscosity of the mirror ink printing to be paid to the choice of a higher mesh screen, using a 300-350 mesh screen printing. 
 Squeegee hardness of 65-75 is appropriate, another angle of 65-75 degrees is the best. 300-350 mesh screen, printing, covering an area of ??up to 25-35 m. 
 4, due to the particularity of the mirror ink, please specify thinner with the following: the Division X301 or pure 783 open water. 
 5, prior to use according to the experience of the printing master the ink as the appropriate dilution and mixing (mixing must adjust ink Killer stir well to being suitable for printing, not use mixer). 
 6, according to the ink and material needs, drying temperature: 180 degrees 15-30 minutes. 
 Second, the performance introduced 
 A mirror ink but printed a positive view mirror effect (eg, mirror-like chrome effect). 
 2, the mirror ink of the Division is not easy to block network, with excellent printability. 
 3, excellent adhesion, cut test of the hundreds of cell resistance to rubbing alcohol, water 
 4, 
 Note: 
 1, due to the complexity of the printed material properties, so the batch before use, the user should be a small amount of trial, to meet the requirements after batch adequately tested to confirm. 
 Protect the ink, printing should overprint, but the selection of inks to be fully qualified pilot, pay attention to avoid the use is not environmentally friendly solvent inks and hurt the mirror effect. 
 3, due to the different proportion of toner of metal, plastic resins, additives and additives, stored in the mirror ink composition will be layered, so must use before using tone ink knife (not a blender) thoroughly Stir in general and mix thoroughly after can be directly printed. 
 4, mirror ink should be stored in a cool dry place, back cover is tightly sealed, to be taken to avoid contact with open flame and high temperature. 
 Note: unknown place to forget the understanding that if any other unknown or technical issues please call the Division I Advisory.